Filter
Top Products
Configuring the domain 85
Step Action
1 Launch the domain quick setup wizard.
>> Main# cfg/quick
2 Specify the pVIP of the Nortel SNAS domain.
You can configure additional pVIPs later (see “Configuring
domain parameters” (page 89)).
IP address of domain portal: <IPaddr>
3 Specify a name for the Nortel SNAS domain, as a mnemonic aid.
Name of the domain: <name>
4 Specify the port on which the portal web server listens for SSL
communications. The default for HTTPS communications is port
443.
Listen port of domain portal [443]:
5 Specify the certificate to be used by the portal server.
Use existing certificate (no/1) [no]:
If certificates exist on the system, the certificate numbers will be
offered as valid input options. Choose one of the following:
a To create a new certificate by pasting in the contents of a
certificate file from a text editor, press Enter to accept the
default value (no). Go to step 6.
b To create a test certificate, press Enter to accept the default
value (no). Go to step 7.
c To use an existing certificate, enter the applicable certificate
number. Go to Step 8.
Use the /info/certs command to view the main attributes of
all configured certificates. The certificate number is shown in the
Certificate Menu line (for example, Certificate Menu 1:).
For more information about certificates and keys, see “Managing
certificates” (page 297).
6 To create a new certificate:
a At the prompt to create a test certificate, enter No.
b When prompted, paste in the certificate and key from a text
file, then press Enter.
c Enter an ellipsis (...) to signal the end of the certificate.
d To continue, go to Step 8.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.