Filter
Top Products
62 Managing the network access devices
a At the prompt to add the SSH key, enter Yes.
b When prompted, paste in the key from a text file, then press
Enter.
c Enter an ellipsis (...) to signal the end of the key.
d To continue, go to step 7.
Do you want to add ssh key? (yes/no) [no]: yes
Paste the key, press Enter to create a new line,
and then type "..." (without the quotation marks)
to terminate.
> 47.80.18.98 ssh-dss
AAAAB3NzaC1kc3MAAABRAJfEJJvYic9yOrejtZ88prdWdRWBF8Q
km9iJz3I6t6O1nzymt1Z1DVMXxCSb2InPcjq3o7WfPKa3VnUNUg
TpESrFlH7ooK+Zys8iEUbmJ3kpAAAAFQCUE/74fr6ACaxJpMcz0
TlWwahdzwAAAFEAgPWVrk0VOOXQmfLhutwaTrxltIDkJzOEIXPf
AIEpvDsvnlNkFE/i2vVdq/GTKmAghfN3BYjRIQT0PAwUKOS5gky
fLG9I5rKqJ/hFWJThR4YAAABQI9yJG5Q7q+2Pnk+tx1Kd44nCD6
/9j7L4RIkIEnrDbgsVxvMcsNdI+HLnN+vmBR5wd+vrW5Bq/ToMv
PspwI+WbV8TjycWeC7nk/Tg++X53hc=
> ...
10 Wait while the wizard completes processing to add the network
access devices, then enter Apply to activate the changes. The
system automatically assigns the lowest available switch ID to
the network access devices.
The switch is disabled when it is first added to the configuration.
Do not enable the switch until you have completed configuring
the system. For more information, see “Configuring the network
access devices ” (page 64).
Creating Switch 1
Use apply to activate the new Switch.
>> domain #
--End--
Manually adding a switch
To add a network access devices and configure it manually, use the
following command:
/cfg/domain #/switch <switch ID>
where
switch ID is an integer in the range 1 to 255 that
uniquely identifies the network access devices
in the Nortel SNAS domain.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.