Filter
Top Products
79
.
Configuring the domain
This chapter includes the following topics:
Topic
“Configuring the domain” (page 79)
“Roadmap of domain commands” (page 81)
“Creating a domain” (page 83)
“Deleting a domain” (page 89)
“Configuring domain parameters” (page 89)
“Configuring the Nortel Health Agent check” (page 92)
“Configuring the SSL server” (page 97)
“Configuring HTTP redirect” (page 107)
“Configuring advanced settings” (page 109)
“Configuring RADIUS accounting” (page 110)
“Configuring local DHCP services” (page 115)
A Nortel SNAS domain encompasses all the switches, authentication
servers, and remediation servers associated with that Nortel SNAS cluster.
If you ran the quick setup wizard during initial setup, Domain 1 is created.
If you did not run the quick setup wizard, you must create at least one
domain. For information about creating a domain, see “Creating a domain”
(page 83).
To delete a domain, see “Deleting a domain” (page 89).
ATTENTION
With Nortel Secure Network Access Switch Software Release 1.6.1, you cannot
configure the Nortel SNAS to have more than one domain.
Configuring the domain
To configure the domain, access the Domain menu by using the following
command:
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.