Filter
Top Products
46 Initial setup
Enter port number for the traffic interface [1-4]:
<port>
Enter IP address for this machine (on traffic
interface): <IPaddr>
Enter network mask [255.255.255.0]: <mask>
Enter VLAN tag id (or zero for no VLAN) [0]:
Enter default gateway IP address (on the traffic
interface): <IPaddr>
10 Specify the time zone.
Enter a timezone or ’select’ [select]: <timezone>
If you do not know the time zone you need, press <CR> to
access the selection menus:
Select a continent or ocean: <Continent or ocean by
number>
Select a country: <Country by number>
Select a region: <Region by number, if applicable>
Selected timezone: <Suggested timezone, based on your
selections>
11 Enter the current date settings.
Enter the current date (YYYY-MM-DD) [2008-03-10]:
12 Enter the current time settings.
Enter the current time (HH:MM:SS) [00:04:10]:
13 Specify the NTP server, if applicable.
Enter NTP server address (or blank to skip): <IPaddr>
ATTENTION
If you do not have access to an NTP server at this point, you
can configure this item after the initial setup is completed. See
“Configuring date and time settings” (page 274).
14 Specify the DNS server.
Enter DNS server address (or blank to skip): <IPaddr>
15 Generate the new SSH host keys for secure management and
maintenance communication from and to Nortel SNAS devices.
Generate new SSH host keys (yes/no) [yes]:
This may take a few seconds...ok
If you do not generate the SSH host keys at this stage, generate
them later when you configure the system (see “Configuring
Nortel SNAS host SSH keys” (page 284)).
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.