Filter
Top Products
Assigning static routes to the management interface 107
Variable Value
cpu-slot <value>
Specifies the Switch Fabric/Central
Processor Unit (SF/CPU) module (
8691SF/CPU or 8692SF/CPU), slot 5 or slot
6. If you do not specify a slot number for
the IP address, the switch assigns the slot
number to the currently active management
module.
ipaddr/mask
Specifies the IP address and subnet mask
of the management port (for example,
10.127.231.15/255.255.255.0). You cannot
assign an address of 0.0.0.0/0.
Assigning static routes to the management interface
Assign a static route to specify a gateway address route for the
management interface. You can specify up to four static routes for
the management interface. For more information about static routes,
see Nortel Ethernet Routing Switch 8600 Configuration — IP Routing,
NN46205-523.
Procedure steps
Step Action
1 Specify a gateway address route by using the following
command:
config bootconfig net mgmt route add <netaddr/mask>
<gateway>
2 Save the changes to the boot.cfg and config.cfg files.
--End--
Variable definitions
Use the data in the following table to use the config bootconfig net
mgmt route add command.
Variable Value
gateway
Configures the IP address of the
default gateway.
netaddr/mask
Configures the IP address and mask
of the destination network in the
formats a.b.c.d/x | a.b.c.d/x.x.x.x |
default.
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Copyright © 2008 Nortel Networks
.