Configuring system identification 87
Table 13
Job aid: Setup utility prompt descriptions (cont’d.)
Prompt Description and action
IP address of the default VLAN
[0.0.0.0/0.0.0.0]:
Description: Specifies the IP address of the
default Virtual Local Area Network (VLAN).
Action: Type the IP address of the default
VLAN.
Do you want to save the
changes
[Saving the parameters
updates the files /flash/boot.cfg
and /flash/dvmrp_pol.cfg]
(y/n)?
Description: Saves your changes to the boot
and run-time configuration files.
Action: Enter y to save the boot and run-time
configuration files. Enter n if you do not want
to save your changes.
Configuring system identification
Configure system identification to specify the system name, contact
person, and location of the switch.
Prerequisites
• You must log on to the Global Configuration mode in the NNCLI.
Procedure steps
Step Action
1 Change the system name by using the following command:
sys name <word>
2 Configure the system contact by using the following command:
snmp-server contact <word>
3 Configure the system location by using the following command:
snmp-server location <word>
--End--
Variable definitions
Use the data in the following table to use system-level commands.
Variable Value
agent-conformance
Enables agent conformance mode.
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Copyright © 2008 Nortel Networks
.