Filter
Top Products
Configuring the time zone 89
Example of configuring system identification
Procedure steps
Step Action
1 Change the system name by using the following command:
ERS-8610:5(config)#sys name ERS-8610
2 Configure the system contact by using the following command:
ERS-8610:5(config)#snmp-server contact
joe.smith@somecompany.com
3 Configure the system location by using the following command:
ERS-8610:5(config)#snmp-server location "12 Main
St, Vancouver, BC"
--End--
Configuring the time zone
Configure the time zone to specify the time zone for your location and
configure settings for Daylight Saving Time (DST).
Prerequisites
• You must log on to the Global Configuration mode in the NNCLI.
Procedure steps
Step Action
1 Configure the time zone by using the following command:
boot config tz
2 Save the changed configuration to the boot.cfg and pcmboot.cfg
files.
3 Reboot the switch.
--End--
Variable definitions
Use the data in the following table to use the boot config tz command.
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Copyright © 2008 Nortel Networks
.