Filter
Top Products
Job aid: Roadmap of initial NNCLI commands 71
Initial commissioning navigation
• “Job aid: Roadmap of initial NNCLI commands” (page 71)
• “Connecting a terminal” (page 73)
•
“Connecting a modem” (page 74)
• “Configuring the switch with the setup utility” (page 81)
• “Configuring system identification” (page 87)
• “Configuring the time zone” (page 89)
•
“Configuring the date” (page 91)
•
“Specifying the primary SF/CPU” (page 91)
• “Changing passwords” (page 92)
Job aid: Roadmap of initial NNCLI commands
The following table lists the commands and the parameters you use to
complete the procedures in this section. The last two columns indicate
which commands support the no and default forms of the command.
Table 10
Job aid: Roadmap of initial NNCLI commands
Command
Parameter
Privileged EXEC mode
clock set
<MMddyyyyhhmmss>
install
show boot config master
Global Configuration mode
boot config master <cpu-slot>
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Copyright © 2008 Nortel Networks
.