Filter
Top Products
Job aid: Roadmap of initial CLI commands 43
Initial commissioning navigation
• “Job aid: Roadmap of initial CLI commands” (page 43)
• “Connecting a terminal” (page 45)
•
“Connecting a modem” (page 46)
• “Configuring the switch with the setup utility” (page 54)
• “Configuring system identification” (page 60)
• “Configuring the time zone” (page 62)
•
“Configuring the date” (page 63)
•
“Specifying the primary SF/CPU” (page 64)
• “Changing passwords” (page 64)
• “Resetting passwords” (page 68)
Job aid: Roadmap of initial CLI commands
The following table lists the commands and the parameters you use to
complete the procedures in this section.
Table 6
Job aid: Roadmap of initial CLI commands
Command
Parameter
config bootconfig master <cpu-slot>
8databits <true|false>
baud <rate>
enable <true|false>
mode <ascii|slip|ppp>
mtu <bytes>
my-ip <ipaddr>
peer-ip <ipaddr>
pppfile <file>
restart
slip-compression <true|false>
config bootconfig sio modem
slip-rx-compression <true|false>
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Copyright © 2008 Nortel Networks
.