Filter
Top Products
Assigning static routes to the management interface 117
Variable definitions
Use the data in the following table to use the boot config net mgmt ip
and sys mgmt-virtual-ip commands.
Variable Value
cpu-slot <value>
Specifies the Switch Fabric/Central
Processor Unit (SF/CPU) module
(8691SF/CPU or 8692SF/CPU), slot
5 or slot 6. If you do not specify a
slot number for the IP address, the
switch assigns the slot number to the
currently active management module.
<ipaddr> <mask>
Specifies the IP address and
subnet mask of the management
port (for example, 10.127.231.15
255.255.255.0).
ATTENTION
You cannot assign an address of
0.0.0.0/0.
Assigning static routes to the management interface
Assign a static route to specify a gateway address route for the
management interface. You can specify up to four static routes for the
management interface. For more information about static routes, see
Nortel Ethernet Routing Switch 8600 Configuration — OSPF and RIP,
NN46205-522.
Prerequisites
• You must log on to the Global Configuration mode in the NNCLI.
Procedure steps
Step Action
1 Specify a gateway address route by using the following
command:
boot config net mgmt route <netaddr/mask> <gateway>
2 Save the changes to the boot.cfg and config.cfg files.
--End--
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Copyright © 2008 Nortel Networks
.