Filter
Top Products
Configuring the remote host logon 111
Variable Value
password <value> Configures the password to enable FTP transfers.
value is the password, up to 16 characters long.
After you configure this password, only FTP is used for
remote host logon.
ATTENTION
This password must match the password for the
FTP server, or the FTP operation fails. Also, if you
configure the password to a valid value, then all
copying to and from the network uses FTP instead
of TFTP. If the user name or password is incorrect,
copying over the network fails.
tftp-debug
<true|false>
Enables or disables debug mode on TFTP/TFTPD. If
you enable debug mode, debug messages appear on
the management console screen. The default is false.
tftp-hash
<true|false>
Enables or disables the TFTP hash bucket display.
The default is false.
tftp-rexmit
<seconds>
Configures the TFTP retransmission timeout. The
default value is 2 seconds. seconds is the number of
seconds (1–2147483647).
tftp-timeout
<seconds>
Configures the TFTP timeout. The default value is 6
seconds. seconds is the number of seconds (1–120).
user <value> Configures the remote user logon. value is the user
logon name (up to 16 characters).
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Copyright © 2008 Nortel Networks
.