Filter
Top Products
English
48 Programming
04 IMAGE IN MCF: When a message confirmation
is printed, this function adds a portion of the first
page your fax machine transmitted. This is printed at
the bottom of the message confirmation report.
Available settings are on and off.
05 SENDER ID: This function controls the printing
of your fax machine’s Sender ID on the faxes you
send. When turned on, your fax machine’s Sender
ID will be printed on each page slightly outside the
image area of your document. When turned off,
your fax machine’s Sender ID will not be printed.
06 MONITOR VOLUME: This function sets the vol-
ume your fax machine uses for telephone line moni-
toring sounds during dialling. Available settings are
low, high and off.
07 BUZZER VOLUME: This function sets the vol-
ume of the various beep and alarm tones your fax
machine emits during operations. Available settings
are low, middle and high.
08 CLOSED NETWORK: This function allows you
to program your fax machine to refuse to receive
faxes from or transmit faxes to locations whose tele-
phone numbers have not been programmed into
your fax machine’s One Touch keys or Auto Dial
numbers. Using this function, you can set up a
closed network of fax machines. If you do not want
your fax machine to transmit faxes to or receive
faxes from locations outside your network, select
T/R. If you only want your fax machine to refuse to
receive faxes from outside your network, select RX.
Available settings are OFF, T/R and RX.
09 TX MODE DEFAULT: This function allows you
to change your fax machine’s default type of original
and transmit resolution settings. Unless you select
otherwise using the Transmit Resolution/Yes
ᮤ
or
Type of Original/No
ᮣ
keys, your fax machine is set
to use the STD and NORMAL settings. If you are
constantly sending faxes which require some other
combination of transmission modes, use this function
setting to change the default transmission modes to
any other combination of settings. While you are
programming, the new default combinations will
appear on the LEDs above the Transmit
Resolution/Yes
ᮤ
or Type of Original/No
ᮣ
keys.
10 T/F TIMER PROG.: When set to the telephone/
fax answering mode, your fax machine automatically
distinguishes between incoming voice and fax calls.
If the incoming call is a voice call, your fax machine
will ring to tell you to pick up the handset. If you
do not answer, your fax machine automatically
switches back to facsimile mode to allow the calling
party to send a fax. The T/F TIMER function controls
how long your fax machine waits before switching
back to fax mode. Available settings are 20 seconds
or 35 seconds.
4100 Fax ENGLISH 15/1/97 9:37 am Page 48