Filter
Top Products
83
Wireless LAN
1 Click on the notification area and click or .
2 Click [802.11a Enabled] or [802.11a Disabled].
A standard user needs to enter an administrator password.
NOTE
In some countries, communication using IEEE802.11a (5 GHz wireless LAN) standard is restricted by law.
The Wireless Switch Utility icon ( or ) indicates the on/off status of wireless LAN and/or wireless WAN, not the
setting of IEEE802.11a.
If IEEE802.11a is enabled or disabled while the computer is connected to an IEEE802.11b/g access point, the connec-
tion will be temporarily interrupted.
You can also change the IEEE802.11a setting in [Device Manager].
A Click (Start) - [Computer] - [System properties] - [Device Manager].
A standard user needs to enter an administrator password.
B Double-click [Network adapters] and double-click [Intel(R) Centrino(R) Advanced-N 6200 AGN].
C Click [Advanced], and then select [Wireless Mode] in [Property].
D Select the settings in [Value] (e.g., [5. 802.11a/g]).
E Click [OK].
A Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager].
B Double-click [Network adapters] and double-click [Intel(R) Centrino(R) Advanced-N 6200 AGN].
C Click [Advanced], and then click [Wireless Mode] in [Property].
D Remove the check mark from [Use default value] in [Value], and select the settings (e.g., [802.11a and 802.11g]).
E Click [OK].
Enabling/Disabling the Wireless LAN Standard IEEE802.11a (802.11a)