Filter
Top Products
Preparing for the Setup
5–8
Ensuring the Printer Connection
Complete the following steps before you configure the server and the
workstations that will print to the DP-C106. A service technician may
have performed some initial installation.
1. Print a Test Page from the Printer Control Panel to ensure that
the printer is functioning normally in a stand-alone mode.
To print a Test Page:
a. Press the MENU button on the printer control panel until the
message PRINT PAGES FROM LIST is displayed.
b. Press the ITEM/ENTER button to display PRINT
CONFIGURATION.
c. Press ITEM/ENTER to print the page.
2. Switch Off the printer and connect the interface cable from the
printer to the server.
3. To confirm the connection, switch On the printer and print another
test page from the Printer Control Panel.
4. With the printer switched Off, connect the network cable to the
network, as described in Connecting to the Network.
The network should already be installed and operational.
5. Switch On the printer.
6. Prepare network servers to share printer software and to enable
networked users to print to the DP-C106.
Refer to Setting Up the Network Server for details.
7. Perform Printer Setup as described in Performing the Setup from
the Printer Control Panel.