Filter
Top Products
1-1
Setting Up the DP-C106
This chapter contains the hardware installation instructions only. To install the printer
driver software, go to the Installing Your User Software chapter. To install to the
network, go to the appropriate chapter for your operating system.
Preparing for the Installation
Before you begin the installation of your Panasonic DP-C106, read this entire
section. You must locate an appropriate site for the installation of the
DP-C106. Reading this section assists you with the decision making process.
Selecting a Location
WARNING
The wall outlet must be rated for 115 or 240 volts. It must also be protected
for at least 15 amps for 115 volts, or 8 amps for 240 volts. If you are in
doubt about a power source, ensure that a qualified electrician checks the
outlet.
Do not connect any other devices to the wall outlet designated for the
DP-C106.
Install the Panasonic DP-C106 in a location that meets the following
conditions:
• The DP-C106 has a designated wall outlet.
• The power cord cannot be stepped on, or be a tripping hazard.
• The location has a level, stable surface.
DO NOT install the DP-C106 in a location that has any of the following
conditions:
• In direct sun light • Near an air conditioner or heater
• In a dusty place • Near an open flame
• In a windy place • Near water
• Where it might be subject to
vibration
• Near a magnetic field
• Where abrupt changes in temperature or humidity occur
1