Filter
Top Products
2. Preparation
19
Volu me
2.5 Adjusting cordless handset
volume
Ringer volume
1. "
2. Select N by pressing {^}, {V}, {<}, or {>}. i #
3. Press {^} or {V} to select “Ringer Setup”. i
#
4. Press {^} or {V} to select “Ringer Volume”. i
#
5. Press {^} or {V} to select the desired volume. i
# i {ih}
Note:
L When the ringer volume is turned OFF, U is
displayed.
When the ringer is turned OFF, the cordless handset
will ring:
– at the minimum level for alarm and intercom calls
– at the maximum level for paging
Ringtone
You can select the desired cordless handset ringtone for
outside calls and intercom calls (page 56). Caller ID
service users can also use a different ringer for each
category (page 29).
Cordless handset receiver volume
While using the receiver, press {V} or {^}.
Speaker volume
While using the speakerphone, press {V} or {^}.
2.6 Adjusting base unit volume
Ringer volume
While the unit is idle, press {A} or {B}.
L If there are any documents in the document
entrance, you cannot adjust the volume. Confirm that
there are no documents in the entrance.
To turn the ringer OFF
Press {B} repeatedly to display “RINGER OFF= OK?”.
i {SET}
L The base unit will not ring for outside calls.
The base unit will ring at the low level for intercom
calls.
L To turn the ringer back ON, press {A}.
Ringtone
L You can select the desired base unit ringtone for
outside calls (feature #17 on page 51).
Handset receiver volume
While using the receiver, press {A} or {B}.
Speaker volume
While using the speakerphone, press {A} or {B}.
{^}{V}{<}{>}
{ih}
{
SET}
{A}{B}
FC255AL-PFQX2639ZA-en.book Page 19 Friday, April 21, 2006 1:50 PM