Operating Instructions
106
3.3.6 Using PPPoE Connection
This function allows you to manually connect/disconnect the PPPoE connection to your ISP. When
cutting this product's power supply, manually disconnect the PPPoE connection before doing so. If the
power is turned off before PPPoE is manually disconnected, it may take some time to re-connect once
the power has been turned back on.
Connecting PPPoE
Disconnecting PPPoE
Notes
• This function can be used irrespective of the type (always or manual) of PPPoE connection.
• If PPPoE is disconnected from the WAN (Internet) side, this product cannot be re-accessed
from the WAN side.
Session keep-alive function
This product has a session keep-alive function. This is when using the always mode of PPPoE
connection, if connection with the ISP's server is disconnected for some reason, the session keep-alive
function automatically tries to regain connection. This function also has the following characteristics:
• It is enabled during always connection mode. During manual connection mode, it will not connect
automatically.
• It will try to regain connection after 1, 2, 3....9, 10 minutes, and every 10 minutes after that.
1. Click [PPPoE Connection] on the setup page.
2. Click [Connect] to start PPPoE connection.
1. Click [PPPoE Connection] on the setup page.
2. Click [Disconnect] to disconnect.