Filter
Top Products
Operating Instructions
86
RA(Router Advertisement)
Note
The RA is disabled when the WAN side IPv6 global address is not assigned.
Link MTU size
This function allows you set the WAN side IPv6 link MTU size. Link MTU size is the maximum packet
size that can be sent within the IPv6 network segment.
The setup page is displayed by clicking Link MTU size.
Notes
• Data speed may be vastly reduced depending on the link MTU settings.
• Some set values may not be used depending on the connection type.
Routing
This function allows you to set dynamic routing and static routing.
The setup page is displayed by clicking Routing.
IPv6 Dynamic Routing
Note
Please note that this product's LAN network information is made accessible to the WAN side when
either Send & Receive or Receive only are selected.
RA Sets whether to Enable or Disable the sending of RA from this
product to the LAN side. Usually, it is not necessary to change this
setting. The default setting is Enable.
IPv6 connection You can set the IPv6 link MTU size to between 1280 and 1500 bytes.
Do not change this setting unless necessary. The default setting is
1500.
LAN Allows you to set Send & Receive, Receive only, Send only, and
Disable path information held by this product, for RIPng supporting
devices on the LAN (Home) side. The default is set to Disable.
WAN When sending path information to the WAN (Internet) side, LAN side
information can be seen from the outside. It is possible to select
Send & Receive, Receive only, Send only, and Disable. The default
is set to Disable.