Panasonic BB-HGW700A Network Router User Manual


 
Operating Instructions
40
3.1.5 Using Camera
The camera page allows you to set up cameras connected to this product.
Usually it is not necessary to set up a camera because the automatic registration function of
Panasonic's Network Cameras sets up the camera name, port number, and IP address automatically.
When changing a camera name, follow the steps on page
43 - changing the setup of automatically
registered cameras. Also, when manually setting up a camera network, register cameras by following
the steps in additional camera registration.
Automatic Setup
Data Entry Field
Automatic Setup Select Enable or Disable.
IPv4 Camera
Available Address
Range
Specify one sequenced address range to be allocated to the
camera.
Be careful that it does not overlap the address allocated by a
server, such as a DHCP/PPTP server.
The default is 192.168.0.151 - 192.168.0.166.
Port Number assigned
to network camera
Select Single port or By range.
If By range is selected, the value of the Available Port Range is
automatically allocated.
Single port can be used in the following situations:
1 When connecting the WAN side to an internal company
network, without using address translation.
2 When using only the LAN without connecting to the WAN
side.
Available Port Range Specify the camera port number.
When selecting By range above, it is only possible to specify one
sequenced port number range. It is necessary to have the same
number of port numbers as available address ranges specified
above, so specify the port number range that you will use.
When selecting Single port above, specify one static port
number.
The default is 60001-60016.