Filter
Top Products
6. Security and Logins
9128-A2-GB20-80 September 2002
6-15
Changing Access Levels
The Operator and Administrator have the same Login ID with different passwords
for their access level. To determine the level of access for a session, refer to
Access Levels (Command Modes)
on page 6-14.
After accessing the router’s CLI:
You can access the Administrator access level by entering:
enable
The router’s defaults to no password required. To require a password to
access the Administrator access level, enter:
enable password
password
Once saved, the router responds with a prompt to enter a password for
Administrator access. This command is in effect until
no enable password
[
password
] is entered and saved.
You can end the current Administrator access level by entering:
exit
This command results in ending the current Administrator access level
session. Exit may need to be entered several times to reach Operator level
and/or end the session.
You can end the Administrator access level by entering:
end
This command results in ending the Administrator access level session and
returning immediately to Operator level.
For further details, refer to
Chapter 5, Configuring the FrameSaver SLV Router,
and Appendix C,
Router CLI Commands, Codes, and Designations
.