Filter
Top Products
8. Troubleshooting
9128-A2-GB20-80 September 2002
8-13
Suboptimal Link Rate,
frame relay link
2
The specified frame relay
multilink has failed to
achieve the configured
Maximum Link Rate for the
link.
This message appears for
multilink aggregate frame
relay links if LMI is down on
any of its constituent links.
No action required.
Two Level-1 Users
Accessing Device
Another user with Level-1
security access is currently
accessing the unit.
Be aware that actions of the
other user may override
your test commands and
configuration changes.
Wait until no other Level-1 users
are accessing the unit if testing or
configuration will be performed.
Yellow at DSX-1 A yellow alarm signal is
received on the DSX-1
interface. DTE has detected
a LOS or OOF condition.
Check that the DSX-1 cable is
securely attached at both ends.
Check the status of the
attached equipment.
Yellow at Network 1 A yellow alarm signal is
received on the network
interface.
Network cable problem.
T1 facility problem.
Check that your network cable
is securely attached at both
ends.
Contact your network provider.
Table 8-1. Alarm Conditions (7 of 7)
Alarm Condition What It Indicates What To Do
1
nnnn
indicates a DLCI number of 16 through 1007.
2
frame relay link
is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port-
n
. The frame relay link associated with a user data port.
–
ISDN Link Name
on a non-network ISDN DBM interface.
3
Does not apply to a TS Access Management Link DLCI.