Filter
Top Products
2. User Interface and Basic Operation
2-2
September 2002 9128-A2-GB20-80
Logging On
Start a session using one of the following methods:
Telnet session via:
— An in-band management channel through the frame relay network.
— A local in-band management channel configured on the DTE port between
the FrameSaver unit and the router.
Dial-in connection using the internal modem.
Direct terminal connection over the COM port.
When logging on, the User Interface Idle screen appears.
If no security was set up or security was disabled, the Main Menu screen
appears (see
Main Menu
on page 2-4). You can begin your session.
If security was set up and is enabled, you are prompted for a login. Enter your
login ID and password.
When the user interface has been idle, a session is automatically ended and the
screen goes blank when the unit times out. Press Enter to reactivate the interface.
Procedure
To log in when security is being enforced:
1. Type your assigned Login ID and press Enter.
2. Type your Password and press Enter.
— Valid characters – All printable ASCII characters
— Number of characters – Up to 10 characters can be entered in the Login
ID and Password fields
— Case-sensitive – Ye s
An asterisk (*) appears in the password field for each character entered.