Philips CF-U1 Personal Computer User Manual


 
77
Troubleshooting (Advanced)
LAN transmission speed slows down
noticeably.
<Only for model with wireless LAN>
Wireless LAN connection is cut.
z These problems may occur due to performance loss that results from the CPU
power-saving function. Log on to Windows as an administrator and follow the
steps below.
A Click [start] - [Run] and input [c:\util\cpupower\setup.exe], and click [OK].
Follow the on-screen instructions.
B Click [start] - [All Programs] - [Panasonic] - [CPU Idle Setting].
C Click [Performance] and click [OK], then click [Yes].
The computer will restart.
z If the problem persists, click [start] - [Control Panel] - [Performance
and Maintenance] - [Power Options] - [Power schemes], select
[Always On] in [Power schemes], and click [OK].
The above remedy is effective for performance loss resulting from the CPU
power saving function, but not for other causes (e.g., noise generated by high
CPU load such as video playback).
The above remedy slightly reduces the battery operation time. Normally it is
recommended to select [Battery (Windows XP Standard)] in [CPU Idle
Setting] and to select [Portable/Laptop] in [Power schemes].
Touchscreen
The cursor does not work. z Connect the external mouse correctly.
z Restart the computer using the keyboard.
(Press (Windows)
*3
,
U
and
R
to select [Restart].)
*3
When the Sticky Key function is enabled (at the time of purchase), press
(Windows)
3 times.
z If the computer does not respond to keyboard commands, read “No response.”
(Î page 81).
Cannot point the correct position using
the included stylus.
z Perform the touchscreen calibration (Î page 10).
Cannot input using the touchscreen z Set [Touchscreen Mode] to [Auto] or [Touchscreen Mode] in the [Main] menu of
the Setup Utility (Î page 61).
Cannot use scroll function of scroll but-
ton on Internet Explorer.
z Use Touchscreen.
z Move the mouse cursor to outside of Internet Explorer, and return to Internet
Explorer.
SD Memory Card
Cannot use an SD Memory Card. z Set [SD Slot] to [Enabled] in the [Advanced] menu of the Setup Utility (Î page
62).
Connecting Peripherals