Filter
Top Products
Polycom® RSS™ 4000 User Guide
1-5
4 (Optional) Select a language for the Web interface from the Select
language list in the top right of the page.
5 On the Login page, enter the administrator’s username and password,
and then click the Log In button.
The default username and password are both admin.
6 The Product Activation page displays when you first-time log in. Enter
the activation key obtained from the previous step Obtaining the Product
Activation Key in the Activation Key box and click Update.
If you do not activate the system, you can still use the Web interface, but cannot
perform calling, recording, live streaming and video playing
operations using the
system.
7 When prompted to restart the system, select No to proceed with setting
the IP address.
8 Click System Config>IP Setting to enter the IP Setting page. Set
following parameters:
Table 1-1 IP Setting Parameters Description
Parameter Description
Obtain an IP Address
Automatically (DHCP)
If the user network is configured with a Dynamic Host
Configuration Protocol (DHCP) server, select this option to
automatically obtain the IP address.
Note
: This option is not recommended as the address
assigned by the DHCP server could change over time.
Using the following IP
Address
Select this option to use the static IP address. You need to
manually enter the IP address, subnet mask, and gateway
IP address.
Obtain DNS Server
Address Automatically
Used in combination with the DHCP option. When the
Obtain an IP Address Automatically (DHCP)
option is
selected, the system will automatically obtain DNS server
address from a DHCP server in the network.
Using the following
DNS Server Address
If you did not select the option to automatically obtain DNS
address, you must enter the preferred/alternate DNS
server addresses here for the system to resolve domain
names.
Using the following
NAT Server
The Network Address Translation (NAT) function of the
system enables you to translate the private network IP
address of packet into a public network IP address before
transmission. To enable NAT, select this check box and
then enter the public network IP address to be displayed
publicly.
LAN Speed
Sets the speed/duplex modes for LAN ports. Supports the
10/100M Full Duplex or Half Duplex mode and the 1000M
network. Select
Auto
to use auto-negotiation.
Note:
When setting LAN port speed, contact your network
administrator to ensure that the switch link rate matches
the system port.
9 Click Update and a dialog box will pop up, in which you should confirm
to restart the system to apply the setting.