Filter
Top Products
Polycom® RSS™ 4000 User Guide
6-3
Reset Password
Type "reset password" after the prompt "#" to restore the administrator user
password for Web login to the default password (admin). The system will
show the prompt message "Are you sure?". Type "Y" to proceed, or type "N"
to cancel.
Restore System Configuration
Type "reset config" after the prompt "#" to restore the following system
configurations to the default value:
• System Config
― IP setting
― System time
― Recording setting
― Security setting (Ports and security policy)
― Service Setting
― Signaling Setting
• Admin
― UI Customization (System name and default endpoint menu
language)
― Disk Warning
The system will show the prompt message "Are you sure?". Type "Y" to
proceed, or type "N" to cancel.
After resetting the system configuration, the system must be restarted in
order for the new settings to take effect.
If you need to completely restore the system please refer to Restoring Factory Default
Configuration.
Clean Activation Key
Type "cleankey" after the prompt "#" to remove the existing activation key.
This command is used to deactivate the RSS™ 4000 system.
The system will show the prompt message "Are you sure?". Type "Y" to
proceed, or type "N" to cancel.
Telnet Setting
Type "telnet {on | off}" after the prompt "#" to turn on/off the telnet session.
For example, enter "telnet on" to enable telnet function.