Filter
Top Products
Chapter 6 – Appendix A – Telnet/Terminal Commands
6-4
The default setting is telnet on. If "telnet off" is entered to disable the telnet function of
the Polycom® RSS™ 4000
, user can only use the serial port to perform above system
setting tasks. The default telnet port is 23, which cannot be modified. The password
and command operations for remote telnet login are identical to those for serial port
login.
Password Modification
Type "set telnet password" after the prompt "#" to modify the login
password for the Command Setting page.
This command is only used to change the login password for the telnet
session and serial interface. It does not impact the Web UI password.
Ping
Enter ping <ip> {-n<count>} {-w<time>} {-l<size>} after the prompt "#" to
check the network connection status.
Table 6-2 Parameters Description
Parameter Description
ip IP address of the destination host
-n<count> Packet sending times, defaulted to 10
-w<time> Waiting time, defaulted to 1000 ms
-l<size> Size of the sent packet, defaulted to 32 bytes
[Example] Send the host whose IP address is 172.21.100.111 a Ping packet
with the size of 1500 bytes for five times cyclically. The wait time is 1000 ms:
Network Setting
Enter the following commands after the prompt "#" to set network
configurations:
“set {lan1 | lan2} ip {dhcp | static <ip> netmask <mask> gw <gateway>}” -
set the IP address for LAN 1 or LAN 2.