Filter
Top Products
Polycom® RSS™ 4000 User Guide
4-33
• All current configuration and recorded archives will be cleared after the system is
restored to the default configuration.
• Before the system restarts to complete restoring to the factory default
configuration, please remove the USB device connected to the system.
Otherwise, after the system restarts, you will receive a default configuration
setting dialog box when you try to log in to the Web UI.
To restore the system to the factory default status:
1 Connect the USB storage device to the USB port on the back panel of the
system.
2 Restart the device manually, or click Restart button on the Shutdown
page (Admin>Shut Down) to restart the system.
3 After the system restarts, log in to the Web Configuration page. A
default configuration setting dialog box will display on the page.
4 You can configure following parameters:
Table 4-24 Default restoration Parameters Settings
Parameter Description
Build-in Account
System built-in default administrator account. The user
name and password can be modified here.
Password
Confirm Password Specifies the confirm password.
Keep current IP setting
Specifies whether or not the default configuration
restoration reserves the current system IP address. If not
selected, the system will reset the IP address to the default
192.168.1.254, subnet mask to 255.255.255.0, and
gateway to 192.168.1.1.
5 Click Next; if you want to continue, enter YES in the box to confirm
restoration, and click OK. Click Back button to go back to the setting
box.
6 Remove the USB storage device before the system restarts to complete
restoration.