Filter
Top Products
3–40 Configuring the Printer
• Inch Select/Length in Inches (the default). This selection allows you to
set the form length in inches. The range is from 1.0 to 33.0 inches, in
one–half inch increments. The default is 11.0 inches.
• 6LPI Select/Length at 6 LPI. This menu selection allows you to set the
paper length in lines. The range is from 6 to 198 lines, in 1 line
increments. The default is 66 lines.
• 8LPI Select/Length at 8 LPI. This menu selection allows you to set the
paper length in lines. The range is from 8 to 264. The default is 88 lines.
Horizontal Image Shift
Horizontal Image Shift specifies the amount to shift an image to the right for
precise positioning on the page. The actual width of the image is not affected.
The allowable range is –20/20 to 20/20 inches, in 1/20 inch increments. The
default is 3/20 inches.
Vertical Image Shift
Vertical Image Shift specifies the amount to shift an image down for precise
positioning on the page. The actual height of the image is not affected. The
allowable range is –100/100 to 100/100 inches, in 1/100 inch increments. The
default is 0/100 inches.
Reprint on Fault
Reprint on Fault enables (default) or disables automatic reprinting after a fault
condition occurs.