Filter
Top Products
GigWorks MKII-16 Switch Model MKII-BASE16
Installer's/User's Manual 59003-01 Rev. A
Removal/Replacement Procedures 5-7
Replacement
If the Switch contains two Power Supplies, either supply is “Hot-Pluggable”.
That is, one supply can be replaced while the Switch is powered-up and operating
as long as the other supply is operating properly.
1. If you are placing a Power Supply in a Power Supply Bay that currently has
a Cover Plate on it, first remove the Cover Plate. Use a large flat-blade
screwdriver to turn each of the two Locking-Screws 1/4 turn
counterclockwise.
If you are placing a Power Supply in a Power Supply Bay that has the
Cover Plate removed, go to the next step.
2. Orient the Power Supply as shown in the drawing on the previous page and
slide it all the way in to the chassis. You will feel the connector on the back
of the Power Supply mate with the connector inside the Power Supply Bay.
The flanges on the Power Supply that contain the Locking Screws should be
right up against the back of the Power Supply Bay.
3. Push the Locking Screws into their respective holes. You may need to turn
them clockwise or counterclockwise in order to get them to go all the way
in. Then use a large flat-blade screwdriver to turn each of the two Locking-
Screws 1/4 turn clockwise.
Power Supply