Q-Logic MKII-BASE16 Switch User Manual


 
3-28 Switch Management
GigWorks MkII-16 Switch Model MKII-BASE16
59003-01 Rev. A Installer's/User's Manual
Switch Utilities — Port Status
depends on the capabilities of the loop devices and what has happened since the
loop was last initialized.
Generally, when a loop is initialized, all Enabled devices that successfully
initialize receive an AL_PA. Thus the Switch knows of their existence and can
report that fact to the Switch Utilities. There may be devices on the loop that are
not powered up or are in Bypass mode. These devices will not receive AL-PAs
and the Switch will not know of their existence. Therefore, the Switch will not
report on them to the Switch Utilities.
The Switch Utilities give you the ability (if the particular device has the ability)
to control the mode of the loop device. That is, you may Enable the device or
place it in Bypass Mode. If the device had received an AL_PA before it was
placed in Bypass Mode, the Switch still knows about it and can report on it to the
Switch Utilities. If you change the mode of a particular device from Enabled to
Bypass, the Switch Utilities will still know about the device. But if you then re-
initialize the loop, that device (now in Bypass Mode) will not receive an AL_PA
and the Switch/Utilities will no longer know about it.
AL_PA Field: This field contains the AP_PA of the loop device.
Status Field: This field contains the current mode of the loop device (Enabled or
Bypass) and, if the device permits, is controllable through the Switch Utilities. To
toggle the mode, select (highlight) the device entry in the Loop Device window
and press the Toggle Bypass/Enable Button.
Login-Status Field: This field indicates whether or not the device is logged in or
not logged in.
Toggle Bypass/Enable Button: Press this button to toggle the mode of the
selected device. Remember that if you place a device in Bypass mode and then
re-initialize the loop, the device will lose its AL_PA.
Reset & Re-Initialize Loop Button: Press this button to both Reset and re-
initialize the loop. Remember that devices that you placed in Bypass mode will
not receive an AL_PA and will disappear from the window when you click the
Refresh button.
Re-Initialize Loop Button: Press this button to re-initialize the loop. Remember
that devices that you placed in Bypass mode will not receive an AL_PA and will
disappear from the window when you click the Refresh button.
Enable all on Loop Button: Press this button to enable all the devices on the
loop that can be enabled. Click the Refresh Button to receive new status.
Refer to the Refresh Button described earlier in this tab description.