Q-Logic MKII-BASE16 Switch User Manual


 
A-4 Reference Information
GigWorks MKII-16 Switch Model MKII-BASE16
59003-01 Rev. A Installer's/User's Manual
Reference Information
Switch Agent : ........................... Allows a network management station to
obtain configuration values, traffic
information, and failure data pertaining to
the Fibre Channels via SNMP through the
Ethernet interface.
TFTP: ......................................... Trivial File Transfer Protocol (TFTP)—
Allows the network management station to
configure the Switch Management interface,
load new Switch control-processor and
management processor firmware into their
respecive Flash memories, reset the Switch, and
test file transfers between the management
station and the Switch’s Ethernet port.
Switch Mechanical
Chassis Dimensions: .................. Refer to Figures A-1 and A-2.
Enclosure Types: ........................ The chassis is shipped with four rubber feet
on the bottom for secure stacking. Cabinet
Mounting Brackets are also shipped with
the chassis. You may mount these brackets
on the front or back of the chassis for
mounting in a Standard 19-inch EIA rack
with either the chassis back or front facing
the front of the equipment rack.
Chassis Support: ........................ The chassis MUST be supported by a shelf
or rails when rack-mounted
Chassis Weight: ......................... 20 kg (45 lbs) maximum configuration
Switch Electrical
Power source loading: ............... 1.7 Amps maximum at 90 to 137 Vac
0.9 Amps maximum at 180 to 265 Vac
Each Power Supply: ................... 140 Watts
Operating voltage: ....................... 90 to 137 Vac; 47 to 63 Hz
180 to 265 Vac; 47 to 63 Hz
Input Fuse Type: .......................... There are two input fuses. Each
fuse is a 4 Amp Slow-Blow, 250V
Littelfuse P/N 218004 or equivalent