Filter
Top Products
Basics
16
1
Turning On the Power
A
Press the operation switch to
make the On indicator goes on.
The display panel will come on.
Note
❒ If the power is not turned on
when the operation switch is
pressed, check if the main pow-
er switch is on. If off, turn it on.
❒
During the warm-up period (less
than 10 seconds for Type 1, less
than 15 seconds for Type 2), you
can use the Auto Start function.
Turning Off the Power
A
Make sure that the platen cover or
the document feeder is in the
right position.
B
Press the operation switch to
make the On indicator goes off.
Note
❒ Even if you press the operation
switch, the indicator do not
goes off and blink in the follow-
ing cases:
• When the platen cover or the
document feeder is open.
• When communication is in
progress with external
equipment.
• When the hard disk is oper-
ating.
Turning Off the Main Power
A
Make sure that the On indicator
goes off.
B
Turn off the main power switch to
make sure the indicator goes off.
Important
❒ Do not turn off the main power
switch when the indicator goes
on or blink Hard Disk or Mem-
ory might be broken.
❒ Pull out the power plug after
you turn off the main power
switch. Hard Disk or Memory
might be broken.
❒ If the main power switch is
turned off, or the power plug is
disconnected, any documents
stored in fax memory will be
lost after approximately one
hour elapses.
AdonisC2_AEcopy110F_FM.book Page 16 Wednesday, October 3, 2001 1:43 PM