Filter
Top Products
Sender Settings
109
2
Sender Settings
Use this function to set sender information.
If the sender's e-mail address is registered in the destination list, the sender can
receive transmission results by e-mail.
Also, if you enable the Stamp Sender Name, the registered sender's name (user
name) appears on the receiver's sheet, lists, and report.
Important
❒ In the destination list, register senders, specify their e-mail addresses, and set
Use Name as [Sender] in advance using “Address Book Management” in
“System Settings”.
❒ If user authentication is set, the user logged in is set as sender. The transmis-
sion result is sent to the logged-in user's e-mail address.
A Place the original, and then select the scan settings you require.
B Press [Transmission Mode].
C Press [Sender Settings].