Filter
Top Products
Sub Transmission Mode
143
2
Stamp
When sending a fax document using the ADF, the machine can stamp a circle
mark at the bottom of the original.
When sending a two-sided document, the document is marked at the bottom of
the front page and top of the rear page.
Important
❒ The optional ADF is required to use this function. Stamp only works when
scanning from the ADF.
A Place the original, and then select the scan settings you require.
B Press [Sub TX Mode].
C Press [Stamp], and then press [OK].
To cancel the stamp, press [Stamp] again before pressing [OK].
D Specify the destination, and then press the {Start} key.