Filter
Top Products
Troubleshooting
114
5
x
xx
x Clearing Misfeeds
R
CAUTION:
Important
❒ When clearing misfeeds, do not turn off the operation switch. If you do, your
copy settings are cleared.
❒ To prevent misfeeds, do not leave any torn scraps of paper within the ma-
chine.
❒ If misfeeds occur repeatedly, contact your service representative.
Note
❒ More than one misfeed location may be indicated. In such a case, check every
applicable area. See the following charts:
• B, C, D, E, F ⇒ p.116
• A, P, Q, U ⇒ p.118
• R(Finisher 3000B)⇒ p.120
• R(Finisher MEC) ⇒ p.121
• R(Finisher MEC BK), W ⇒ p.122
❒ You can find a sticker explaining how to remove misfed paper inside the front
cover or finisher.
❒ If detailed procedure appears on the right of the screen, refer to it when re-
moving the sheet.
A After each step, press [Next]. To check the previous step again, press [Previ-
ous].
B After completing the last step, open the machine's front cover, and then fol-
low the instructions on the back of the cover.
C Close the front cover.
• The fusing section of this machine might be very hot. Caution should be tak-
en when removing misfed paper.
VenusC1_GB_zen_Pre_FM.book Page 114 Tuesday, January 17, 2006 3:27 PM