Filter
Top Products
Specifications
180
8
• You can load up to 10 envelopes (80 — 95 g/m
2
, 24 lb.) in the bypass tray at
the same time, without compressing them. Check the envelopes are not
damp, and the top of the stack is not higher than the limit mark on the side
guide.
• When loading envelopes, be sure to unfold the flaps and position them oppo-
site to the paper feed direction.
• With a type D envelope, as shown below, fold the flap and load the envelope
with the fold of the flap against the side guide and the flap underneath.
• Depending on the envelope type, specify appropriate print image rotation
with the printer driver. For a type A or B envelope, specify 180 degrees; for
a type D, 90 degrees or 270 degrees.
• Check there is no air in the envelopes before loading.
• To get better print quality, it is recommended that you set the right, left, top,
and bottom print margin, to at least 15 mm (0.6”) each.
• You cannot print envelopes with duplex function.
• Load only one size and type of envelope at a time.
• Before loading envelopes, flatten leading edges (the side going into the ma-
chine) by pressing a pencil or ruler across them.
• Before loading envelopes, check they are rectangular in shape.
AFU131S
AFU145S
VenusC1_GB_zen_Pre_FM.book Page 180 Tuesday, January 17, 2006 3:27 PM