Filter
Top Products
116
Troubleshooting
3. Close the ink collector unit cover slowly.
If the message reappears, contact your service representative.
z
p.120 "Where to Inquire"
Out of Printable Temperature Range
Follow the procedure below to relocate the printer when the temperature inside the printer is inappropriate,
extremely high or low, for printing.
1. Turn off the power of the printer.
2. Place the printer in a 10 to 32°C (50 to 89.6°F) environment.
3. Turn on the power of the printer.
z
If humidity is more than 54%, the high end of the appropriate temperature range will be lower than usual.
z
Even after the power is turned on, the printer may remain in the standby mode until it acclimates to the room temperature. If this happens,
wait until the [Power] key stops blinking and stays lit.
z
For details about what conditions the printer can be used under (ambient temperature and humidity range), see "Checking the Installation
Area",
Setup Handbook
.
Printer Error
An error has occurred in the printer. Turn the power off once, and then turn it back on.
z
If the printer is relocated from a cold area to a warm area or the printer is placed in a room where the temperature varies greatly, condensa-
tion may form inside the printer causing errors. If this happens, an error might not clear if the power is turned off and then on. Wait until the
printer acclimates and the condensation disappears. This should take about one hour.
z
If the error still does not clear after the printer acclimates to room temperature and the power is turned back on, contact your sales or service
representative.