Filter
Top Products
64
Making Printer Settings
5. Press [ ] or [ ] key to select the lead time needed to switch to the Energy Saver mode.
6. Press the [#Enter] key.
The [System] screen appears.
7. Press the [Online] key.
The initial screen appears.
Host Interface Menu
In the Host Interface menu, you can make network settings and settings for the computer to printer USB connec-
tion (if used). Settings made using the Host Interface menu remain effective even if you turn the printer off.
I/O Timeout
Specify how long the printer waits for the currently-connected interface to respond. When the specified time
elapses, the printer can receive data from another interface.
If you make the [I/O Timeout] period too short, timeout might occur while data transfer is in progress. If this
happens, the print job will be interrupted by a new job from another interface.
z
10 seconds
z
15 seconds
z
20 seconds
z
25 seconds
z
60 seconds
Default: 15 seconds
Network Setup
You can make network-related settings.
DHCP
You can specify the DHCP.
z
On
z
Off
Default: On
IP Address
You can specify the IP address.
When DHCP is set to on, the IP address cannot be changed. To change it, set DHCP to off.
Contact your network administrator for information about the network configuration.
Default: 0.0.0.0
Subnet Mask
You can specify the subnet mask.
When DHCP is set to on, the subnet mask cannot be changed. To change it, set DHCP to off. Contact
your network administrator for information about the network configuration.
Default: 0.0.0.0
E.Saver Timer:
*15 minutes