Filter
Top Products
31
Roll material must be placed at a
predetermined shaft position.
Failure to do so may
result in falling of the
roll, leading to injury.
Pass the stoppers onto both ends of the shaft.
(The shafts (2 pieces), stoppers (2 pieces), and screws
(2 pieces) are included with the stand.)
* When passing the shaft through the stopper,
be sure to loosen the screws on the stopper
first.
1
Loading Roll Material
Attach the media flanges to match the inner diameter of the roll-material core. Insert them firmly, as far as they will go.
(The media flange is included with the stand.)
2
1 Loading the Material
Stopper
Shaft
Media flange
50.8 mm
(2 in.)
76.2 mm
(3 in.)
Setup for Cutting
Setup for Cutting
Tighten loosely with the screws.
Acceptable material widths
131 to 1371 mm (5-3/16 to 54 in.)
*However, when loading material with a width
of 131 to 430 mm (5-3/16 to 17 in.), set the
[EDGE SENSE] menu item to [DISABLE].
Media flange
Media flange