Filter
Top Products
77
Description of Keys
Default
value
Setting
range
FunctionSubmenu
Top
menu
Key
—— — —This switches on and off the sub power . When the
power is switched on, the POWER LED lights up.
—— — —This detects the presence of material, and its dimensions,
and shows the printable or cuttable size on the display.
The SETUP LED flashes while detection of material
width is in progress. When setup finishes, the SETUP
LED lights up continuously.
Also press this key when removing the material.
—— — —The [PAUSE] key pauses operation. The PAUSE LED
lights up while paused.
Pressing this key again cancels the paused state.
Holding down the [SETUP] key for about 1 second
while paused causes remaining data to be cleared and
cancels the material's setup state.
—— — —This sets the present blade position (blade center) at the
printing or cutting start location (base point).
For more information, see "User's Reference -- Perform-
ing Cutting or Printing at the Desired Location."
PRINT
MODE
—
[PRINT MODE]
PHOTO
SUPER
FINE
FINE2
NORMAL
FAST
DRAFT
[PRINT
DIRECTION
]
UNI-DIRECTION
BI-DIRECTION
[PRINT MODE]
FINE2
[PRINT
DIRECTION
]
BI-DIREC-
TION
This displays the [PRINT MODE] menu for setting
image quality.
This is used to specify the printing quality and unidirec-
tional or bidirectional printing.
Settings cannot be made while printing is in progress.
To exit the [PRINT MODE] menu screen, press the
[MENU] key or the [CLEANING] key or the [SETUP]
key.
For more information, see "Setup for Printing -- Setting
the Printing quality and Printing direction."
—— — —This sets an align point for correction when the material is
not straight.
The angle of the material, referenced from the base point,
is stored in memory. Any angle of 5° or less may be set.
This setting is valid only when cutting.
FORCE — [FORCE]
30 to 200 gf
(In steps of 5 gf)
[SPEED]
1 to 60 cm/s
(In steps of 1 cm/s)
[OFFSET]
0 to 1.5 mm
(In steps of 0.025 mm)
[UP-SPEED]
1 to 60 cm/s
(In steps of 1 cm/s)
[FORCE]
50 gf
[SPEED]
40 cm/s
[OFFSET]
0.25 mm
[UP-SPEED]
60 cm/s
This enters the menu for setting the conditions for
cutting.
You can set the values for blade force, cutting speed,
blade offset compensation, and tool movement speed
when raising the tool.
For more information, see "Display Menus Flowchart."
* When [COMMAND] on the display menu has been
set to [ENABLE], the program’s settings for the
cutting conditions take priority.
To give priority to the cutting conditions set on the
machine, turn off the program settings, or set the
[COMMAND] menu to [DISABLE].
For more information about the [COMMAND] menu,
see the section “Descriptions of Menu Items -
Description of Menus.”
Description of Keys