Filter
Top Products
38
Before performing printing and cutting, set up the machine as follows.
1 Loading the Material
Refer to “Setup for Printing -- 1 Loading the Material” and load the material correctly.
2 Installing a Blade
Refer to “Setup for Cutting -- 2 Installing the Blade” and install the blade correctly.
3 Test Printing
Refer to “Setup for Printing -- 2 Printing Test” and check the state of the heads.
4 Setting the Printing Mode and Printing Direction
Refer to “Setup for Printing -- 3 Selecting the Printing Mode and Direction of Printing” and make the settings for the modes.
5 Test Cutting
Refer to “Setup for Cutting -- 3 Cutting Test” and perform a cutting test and adjust the cutting conditions.
Setup for Printing and Cutting
Setup for Printing and Cutting
When cutting is performed after printing, the cap tip of the blade holder may scratch the printed surface. If this is the
case, lengthen the cutter blade extension.
Also, when time is required for the printed surface to dry, you can ensure an automatic wait for a fixed interval after
printing before cutting starts. For detailed information, go to the "Description of Menu Items" chapter, and under "De-
scription of Menus," see [DRYING TIME]. Note that in cases where you can also make this setting using the program,
the setting made here takes priority. Check the documentation for the program.