Filter
Top Products
92
Error Messages
Meaning
A motor error occurred.
The air temperature where installed is higher than
the ambient temperature at which the unit can op-
erate (approx. 40°C (104°F) or more higher).
The air temperature where installed is lower than
the ambient temperature at which the unit can op-
erate (approx. 5°C (41°F) or more lower).
The [SETUP] key was pressed even though no
material is loaded.
Setup was performed with no material at the cor-
rect location.
[EDGE SENSE] is set to [ENABLE], but trans-
parent material was loaded.
An attempt was made to load material that is too
small.
The [SETUP] key was pressed with the pinch roll-
ers up.
The pinch rollers were raised during setup.
The [SETUP] key was pressed while the right-hand
pinch roller was at a location where there is no grit
roller.
The [SETUP] key was pressed while the right-hand
pinch roller was at a location where there is no grit
roller.
An attempt was made to set the print-start location
at a position beyond the printing/cutting area.
An attempt was made to set the align point at the
same location as the base point.
An attempt was made to set the align point at a
location described below.
• Tilted 5 degrees or more from the base point
• Separated from the base point by 20 mm (13/16
in.) or more in the feed direction
Action
Recovery from this problem is impossible.
Use the POWER key to switch the power off and
back on again.
After rectifying the cause of the error (a material
jam or the like), switch on the power.
Do not leave the unit with the carriage not in
standby position.
Recovery from this problem is impossible. Use
the [POWER] key to switch the power off. First
raise the temperature of the area where installed,
then switch on the power.
Recovery from this problem is impossible. Use
the [POWER] key to switch the power off. First
raise the temperature of the area where installed,
then switch on the power.
Load material at the correct location and press the
[SETUP] key again.
When using transparent material, set [EDGE
SENSE] to [DISABLE] (see "Description of
Menus").
Replace with material of loadable size.
Move the sheet loading lever all the way to
“LOAD” to lower the pinch rollers, then press the
[SETUP] key (see "Loading the Material").
Position the right-hand pinch roller correctly (above
a grit roller), then press the [SETUP] key.
Position the left-hand pinch roller correctly (above
a grit roller), then press the [SETUP] key.
Use the arrow keys to move the carriage marker
to a place within the printing area, then press the
[BASE POINT] key (see "User's Reference -- Per-
forming Printing/Cutting at the Desired Location").
Set the align point at a proper position (see "User's
Reference -- Remove the Printed Material, then
Reload the Material and Perform Cutting").
Set the align point at a proper position (see "User's
Reference -- Remove the Printed Material, then
Reload the Material and Perform Cutting").
Error messages
MOTOR ERROR
TURN OFF POWER
TEMPERATURE
IS TOO HIGH
TEMPERATURE
IS TOO LOW
INVALID SHEET
SET SHEET AGAIN
SHEET TOO SMALL
SET SHEET AGAIN
PINCHROLL ERROR
DOWN PINCHROLL
PINCHROLL ERROR
INVALID RIGHTPOS
PINCHROLL ERROR
INVALID LEFTPOS
BASE POINT ERROR
ALIGN WIDTH
ERROR
ALIGN ANGLE
ERROR
Error Messages