Filter
Top Products
71
User's Reference
Adjusting the Height of the Printing Head
When using material that is thick or susceptible to warping, material feed may not proceed smoothly, or the material may jam. When
such material is loaded, you can adjust the height of the printing head. You can adjust the head height by moving the lever in the figure
any of the positions from 1 to 3, where it clicks into place.
This should normally be left at position 1. If printing results in jamming of the material, the material catching on a printing head, or
other problems that indicate that material feed cannot be accomplished smoothly, then position the lever at 2 or 3.
.
When the height of the printing head has been adjusted, it is necessary to perform bidirectional correction (only when the printing
direction for [PRINT MODE] has been set to [BI-DIRECTION]). For more information about bidirectional correction, see "Making
Corrections for Printing - Bidirectional Correction."
Height of the printing head
3
2
1
High
Low
3
1
2
Lever
* Be sure that the carriage
is in standby position
before attempting to
move the lever.