Filter
Top Products
34
Pass the material between the pinch rollers and the grit
rollers as shown in the figure.
1
Move the sheet loading lever toward LOAD.
The pinch rollers lower to hold the material in place.
3
Close the front cover.
Use the [
] and [ ] keys to select [PIECE], then
press the [ENTER] key.
4
Loading Flat Material
Refer to steps 5 and 6 in "Loading Roll Material," and
position the material and the pinch rollers correctly.
2
• When loading flat material, if the material touches the shaft or roll material at the back of the unit, remove the shaft
and roll material.
• If the sides of the material have warped, then bend back the warp or feed the warped portion to the front and
perform setup again.
Press the [SETUP] key. This detects the width and
length of the material and shows the printable width
and length on the display.
5
If a pinch roller is positioned over an area where is no
grit roller, the massage shown at below appears when
you press the [SETUP] key.
PINCHROLL ERROR
INVALID LEFTPOS
or [RIGHT]
The SETUP LED lights up
*If the material is misaligned and looks like it might
come loose from the pinch rollers, or actually does
come loose, please reload the material.
Pass the material
Setup for Cutting
If [PIECE] does not appear, set [EDGE SENSE]
to [ENABLE].
Sheet loading lever
When moved partway,
only the right-hand pinch
roller descends.
Data cannot be output
while in this state. To
secure the material in
place, move all the way
to "LOAD."
SETUP SHEET
ROLL EDGE PIECE
Top menu
W1000mm L ---mm
FINE BI-DIR