Filter
Top Products
Introduction
The installation assumes the following:
The Dual UltraLink consists of two independent
modules. Each one must be set-up and configured.
You have an active Ethernet TCP/IP network.
You are connecting the UltraLink to two standalone
computers or a KVM switch.
You have a PC on the network where you will
install the Viewer software.
Connections
Connect the cables to the UltraLink.
Connect a keyboard, monitor, and mouse to the
appropriate connectors on one or both modules..
Connect two network cables (not provided) to a
10MB or 100MB Ethernet network port or hub.
Connect two DB25 connector to a KVM switch or
two standalone computers with one of the provided
cables. Use the DB25 to DB25 cable to connect to
the KVM port of a Rose KVM switch. Use the
DB25 to HD15-PS2-PS2 cable to connect to a
standalone computer or another KVM switch.
Note: These instructions do not apply to installation of
the local KVM port. Please refer to the UltraLink
manual for instructions on how to connect it.
UltraLink configuration
G
Configure the UltraLink IP addresses
Power on the UltraLink and you will see its
start-up splash screen. Wait for the green screen.
Hit F10 to go to the UltraLink configuration. The
screen changes color from green to gray.
Hit F1 if you want to read some help.
Enter a user ID of “admin” with no password.
Enter the IP address, subnet mask, optional
gateway address, TCP port, and Speed/duplex.
Hit F10 to save the network information.
The UltraLink is now active at this address.
Repeat the above set-up for the other module. .