Filter
Top Products
Connections
7
UltraLink User Manual
Connections
There are two ways to connect the UltraLink
The local KVM is a KVM station connected directly to the UltraLink. It can access
the Switch/CPU device attached to the UltraLink with the connect login described
later. If you don’t need the local KVM (example in the Quick Start Guide) then
connect the cables as shown in Figure 3. This simplifies the cabling and allows you
to view the power up progress of the UltraLink. The keyboard, monitor, and mouse
can be removed after using them to configure the UltraLink’s IP address.
If you require the local KVM, connect the cables as shown in Figure 4. When
connected in this way, you will not see anything on the local monitor until the
UltraLink completes its power-on process (about 25 seconds).
SWITCH/CPU
NETWORK
KEYBOARD
MONITOR
MOUSE
Figure 3 Cable connections, local KVM not used
SWITCH/CPUNETWORK
VIDEOLOOPCABLE
KEYBOARD MONITORMOUSE
Figure 4 Cable connections, local KVM used