Filter
Top Products
Menu Commands
19
UltraLink User Manual
Menu Commands
File
The File menu contains the following commands as shown in the figure below:
• Flash Update
• Save Bitmap
• Exit
Figure 15 File menu commands
Flash Update
The Flash Update command, available to administrators, allows the Viewer to update
an UltraLink with new firmware. The command prompts for the name of a flash
update file. Flash update file names take the form ulpxxx.bin, where xxx is an
update version. When an upload completes, the UltraLink breaks the connection with
the Viewer and restarts to activate the new firmware. Wait at least one minute before
reconnecting to the UltraLink.
Save Bitmap
This command saves the image in the Viewer display area to a bitmap file. In
quad-
screen
view, all the quadrants are saved to the bitmap file. The Viewer saves the
display area only and not the title bar, menus, toolbar or status bar. This operation is
available only when you are logged in to an UltraLink.
Exit
The Exit command causes the Viewer application to terminate execution. If the
Viewer is logged in, the Viewer exits pass-through mode and disconnects before
closing.