Filter
Top Products
Introduction
The installation assumes the following:
You have an active Ethernet TCP/IP network.
You are connecting the UltraLink to four standalone
computers or a KVM switch.
You have a PC on the network where you will install
the Viewer software.
Connections
Connect the cables to the UltraLink.
The Quad UltraLink consists of four independent
modules. Each one must be setup and configured.
Connect a keyboard, monitor, and mouse to the
appropriate connectors on one of the modules.
Connect a network cable (not provided) to your 10MB
or 100MB Ethernet network port.
(Note: The four network outputs can be connected
to a hub)
Connect the DB25 connectors to a KVM switch or to
four standalone computers with one of the provided
cables. Use the DB25 to DB25 cable to connect to
the KVM ports of a Rose KVM switch. Use the Db25
to HD15-PS/2-PS/2 cable to connect to a standalone
computer or another KVM switch.
Note: These instructions apply for each of the 4 modules
UltraLink configuration
J
Configure the UltraLink IP address
Power on the UltraLink and you will see its
start-up splash screen. Wait for the green screen.
Hit F10 to go to the UltraLink configuration. The
screen changes color from green to gray.
Hit F1 if you want to read some help.
Enter a user ID of “admin” with no password.
Enter the IP address, subnet mask, optional gateway
address, TCP port, and Speed/duplex for this
UltraLink.
Hit F10 to save the network information.
This UltraLink is now active at this address.
Repeat the above procedure for each of the four
UltraLink modules.