Filter
Top Products
8. Close the Print Head and place the printer on-line.
9. The Label Dispense Option is ready for use.
LABEL DISPENSE OPTION CL408 and CL412
The CL408 and CL412 have an internally mounted Label Dispense Option which
rewinds the label backing as the labels are stripped. When the Label Dispense
Option is installed and configured for operation, the printer dispenses one label at a
time, peeling the backing from the label, which allows for immediate application to
the product by the operator.
Operator Setup
The following steps should be taken to set up the Label Dispense Option.
1. Install the Label Dispense Option using the instructions provided with the unit.
The installation time is approximately 30 minutes.
2. Power the printer OFF.
3. The printer must be configured to used the Label Dispense Option. Switches
DSW3-1 and DSW3-2 on the front panel are used to configure the printer. To
enable the dispenser, both DSW3-1 and DSW3-2 should be in the ON position.
4. Remove enough labels from the backing paper to provide 24 to 30 inches of
backing free of labels.
5. Open the Top Access Door and the Front Access Door.
6. The Backing Idle Roller is held closed by the green Front Access Door Latch
( the Front Access Door is held in the closed position by a magnetic latch when
the Label Dispense Option is installed). Push down on the rear of the Front
Backing
Take-Up
Spindle
Backing Idle
Roller
Label
Backing
Front
Access Door
Spindle
Handle
Backing
Drive Roller
Backing
Retainer
Prong
Label Backing Path, CL408/CL412
Appendix D: Optional Features
PageD-49001035Rev.ESATOCLSeriesPrinters