Filter
Top Products
LABEL: LED, illuminated when label supply is out.
RIBBON: LED, illuminated when ribbon motion sensor does not
detect any ribbon motion.
ERROR: LED, illuminated when there is a system fault such as
an open print head.
ONLINE: LED, illuminated when printer is ready to receive data.
It is turned on and off by toggling the LINE key. This
indicator will blink while the printer is receiving data.
LINE: Momentary switch. Pressing this key toggles the
printer between the on-line and off-line mode. When
the printer is on-line, it is ready to receive data from
the host. This key acts as a pause during a print job by
taking the printer off-line. It can also be used as a
Pause
function key to stop label during the printing
process.
FEED: Momentary switch. Pressing this key feeds one blank
label through the printer when it is off-line. When the
printer is on-line, another copy of the last label will be
printed.
DSW2-3: Located behind the Front Access Door. DIP switch
array to set operational parameters of the printer.
DSW1 is used to set the RS232 parameters and is
located on the RS232 interface board.
LCD: 2 Line x 16 Character LCD display. Used for setting
operational parameters of the printer.
Section 2. Installation and Configuration
SATOCL Series Printers9001035 Rev. EPage 2-13